Eccentricity parameters of hydrodynamic plain bearing
https://doi.org/10.46973/0201-727X_2024_2_188
Abstract
The paper considers the calculation of determining the eccentricity parameters of the plain bearing based on the determination of angular coordinates in a material-aggregate model tested on an II5018 friction machine. Analysis of the obtained data makes it possible to establish the specified position of the eccentricity and the average position of the thickness of the lubricant layer h0, as well as to determine the values and positions of the minimum film thickness hmin in the contact area of the mating bodies without using approximate or specified values of the angular coordinate of the eccentricity, thereby increasing the research accuracy in the field of friction. The results of eccentricity parameters are presented with calculated tabulated values in the form of comparative tabular values.
About the Author
V. N. Polyakov
Rostov State Transport University (RSTU)
Russian Federation
Russian Federation
Polyakov Vladimir Nikolaevich, Faculty of Civil Engineering, Engineer
References
1. Friction, wear and lubrication. Directory. In 2 books. Book 2. Vol. 66 / Ed. I. V. Kragelsky and V. V. Alisina. – Moscow : Mechanical Engineering, 1979. – 358 p.
2. Myshkin, N. K. Friction, lubrication, wear. Physical foundations and technical applications of tribology / N. K. Myshkin. – Moscow : Fizmatlit, 2007. – 368 p. – ISBN 978-5-9221-0824-9.
3. GOST ISO 7902-1-2001. Hydrodynamic radial sleeve bearings operating in stationary mode. Round cylindrical bearings. Part 1. Calculation method. By Decree of the State Committee of the Russian Federation for Standardization and Metrology dated February 19, 2002 No. 67-st, the interstate standard was put into effect directly as a state standard of the Russian Federation on July 1, 2002.
4. GOST ISO 7902-2-2001. Hydrodynamic radial sleeve bearings operating in stationary mode. Round cylindrical bearings. Part 2. Functions used for calculation. By Decree of the State Committee of the Russian Federation for Standardization and Metrology dated February 19, 2002 No. 67-st, the interstate standard was put into effect directly as a state standard of the Russian Federation on July 1, 2002.
5. Goryacheva, I. G. Mechanics of frictional interaction. – Moscow : Science, 2001. – 478 p. – ISBN 5-02-002567-4.
6. Kokhanovsky, V. A. Supporting surface of slipping frictional systems / V. A. Kokhanovsky, V. N. Polyakov // Bulletin of mechanical engineering. – 2021. – No. 3. – P. 53–56. – DOI 10.36652/0042-4633-2021-3-53-56.
7. New methodology for studying the tribological properties of lubricated friction pairs using the “shaft-bush” method / V. N. Polyakov, I. M. Elmanov, G. V. Darovskoy [et al.] // Friction and lubrication in machines and mechanisms. – 2015. – No. 8. – P. 40–42. – ISSN 1819-2092.
8. Handbook of tribological engineering / edited by M. Hebdy, A. V. Chichinadze // In 3 volumes. Vol. 1. Theoretical basis. – Moscow : Mechanical Engineering, 1989. – 400 p.
9. Sommer, E. F. Study of the position of the spike in the liner of a one hundred twenty-degree fluid friction bearing under constant and alternating loads / E. F. Sommer // Friction and wear in machines, collection 13. – Moscow : USSR Academy of Sciences, 1959.
10. Darovskoy, G. V. Procedures for measuring thickness of lubricating film using capacitive method on Amsler-type friction machines / G. V. Darovskoy, V. N. Polyakov, A. N. Opatskikh // Tribology – mechanical engineering. Proceedings of the XIII International Scientific and Technical Conference. – 2020. – P. 100–104. – ISBN 978-5904282-10-3.
11. GOST 23.204-78. Ensuring wear resistance of products. Method for assessing the abrasive ability of surfaces during friction. Interstate standard, No. 3283. – Moscow, 1980.
12. RD 50-339-82. Ensuring wear resistance of products. Test method for wear using an abrasiveoil layer. – No. 4659. – Moscow, 1982.
Review
For citations:
Polyakov V.N. Eccentricity parameters of hydrodynamic plain bearing. Vestnik Rostovskogo Gosudarstvennogo Universiteta Putej Soobshcheniya. 2024;(2):188–193. (In Russ.) https://doi.org/10.46973/0201-727X_2024_2_188
Views:
6
JATS XML
Email this article 